1995 Johnson 150 Fast Strike PROBLEM 1995 Johnson 150 Fast Strike PROBLEM
Bass Fishing Home PageTM    Boats and Motors  
Boating Equip.
Guides
Tackle Shops
Fishing Acc.
Lodging


7-11-2013

Fishing Reports
BFHP Articles
Fishing News
Tournaments
Fishing Tactics
Places to Fish
Rods/Reels
Electronics
Boats/Motors
Boat Ramp Stories
Trailers/Towing
Props
Other Topics
Other Fishing Topics
Swap/Sell
Swap/Sell (no boats)
Props 4 Sale

Boats 4 Sale
Saltwater Fishing
Non-Fishing
Striped Bass
Lure Making
More Politics
Co-Anglers


Boats and Motors

    1995 Johnson 150 Fast Strike PROBLEM
from Mike (24.229.121.185)  
6/24/2005 9:18:00 PM

Rated:

 Tonight I had to limp back to the ramp at 1100 rpms. It would do no more or it would stall. When I left the ramp the boat ran fine at 4100 RPM but seemed to have an ocassional hesitaation that I didn't think much of since it has been sitting for two weeks. After no-wake zoning up a creek for a mile and then returning to the main lake another mile, I went to opening her up and NOTHING more than 1100 - 900 rpms or she would die. I have a water/fuel seperation filter and that was clean. Is there another in-line fuel filter in the motor? (It may not even be a fuel problem) No oil injector or any other alarms went off)


Any help would be greatly appreciated since I was planing on taking her on vacation next week and I know the Boat shop won't be able to look at it in time.


Rate this message:
1 Star

2 Star

3 Star

4 Star

5 Star

   Motor from Kenny (216.79.246.165)  6/24/2005 9:37:00 PM
 You might try replacing your fuel primer bulb. My engine did the same thing once and the check valves had come loose in the bulb.


   Check power pack. No Msg. from Mitch Welch (205.188.116.67)  6/24/2005 10:14:00 PM
 No msg.


   Faststrike from BobH (141.152.26.242)  6/25/2005 7:55:00 AM
 Another possibility is that one of the float valves in a carb came off. This would flood other carbs causing the engine to stall. Did you leave a trail of fuel behind the boat?


   Shop says two weeks from Mike (24.229.121.185)  6/25/2005 12:10:00 PM
 I would like to figure this out sooner if possible. I hooked up the hose and the motor started right up. It would rev to 4000 and when in gear would also rev up there, but it seemed to be breaking up a bit. Could that be because it was not under load or ?. If the power pack was bad, would I be able to start it up and run it? If so, is there any way to trouble shoot the power pack? Thanks


   yes it will run with a bad power pack. from jeff m (12.210.25.44)  6/25/2005 7:35:00 PM
 not sure if that is your problem . but they do run with a bad powerpack , they do many dif. things when going out . jeff


   Not sure about your OMC from Gstream15  6/25/2005 8:16:00 PM
 but my Merc has done that a couple of times. It was the stator both times.


Name:

Password:

Can't remember your password? Click here!
State:
Email Address:

Users with subscriptions can attach pictures to their comments by using the form at http://www.wmi.org/newboard/upload_pictures/"

Subject:

Comments:


 

Advertising/Sponsor Information
Subscriptions
Register to post messages and reports

7-11-2013

Subscribers don't receive these ads


Fishing Reports
BFHP Articles
Fishing News
Upcoming Events
Rally Page
BFHP Surveys
Fishing Tactics
Places to Fish
Rods/Reels
Electronics
Other Topics
Product Evaluations

Boats/Motors
Boat Ramp Stories
Trailers & Towing
Boats For Sale
Tournament Tactics
Striped Bass

Swap/Sell
Clubs 
Fly Fishing
Hunting
Props
Fish4
Saltwater Fishing
Non-Fishing
Political Hook
Tall Tales, Fiction & Legend
Complete Listing of Boards
Copyright © WMI, Inc. 1995-2014. All rights reserved.
This message board created and maintained by: WebMasters International, Inc. (WMI) address mail to wmi@wmi.org

WMI disclaimer
Privacy Statement

Google