Saltwater Fishing Home PageTM     
Anglerworld.com


Boating
Tackle Shops
Charters & Guides
SW Reports
Surf Fishing
SW Flyfishing
Swap/Sell
SW Fishing
SW Boats for Sale
Striped Bass
Shrimping
Boating
Boat Ramp
Electronics
Trailers/Towing
Texas SWF
Florida SWF
NC SWF
NJ SWF
Fishing Access
Fishing Cats

7-13-2013

SUBJECT: # 40087: Capt. Ken Roy - Questions about your ice chest construction

Submitted by FreeOnBoard from TEXAS on 4/29/2009 12:45:00 PM

I tried a couple of your email addresses, but both came back as undeliverable.
Seem to recall that several years ago you built a custom fit ice chest. I'm in the process of doing that now with polystyrene foam, and practical information is hard to find around here. In particular, I'd like to know what type of foam and what type of adhesive you used, and were you pleased with their performance? The choices around here seem to be 3M 77 and 3M 90, both available at Home Depot, and 3M 78, available on line. Also, are there any problems getting epoxy/glass to adhere to the foam? Thanks for any info you can provide.


  1. 9/29/2009 11:48:00 AM Submitted by Capt. Ken Roy from FL says Cooler
    I lost one e-mail address in a legal dispute and the next one when Earthlink became embarq. I think you can reach me through the email address I have on this site now.


Go to next message
Go to previous message

Category:


To post a followup to this subject use the following form:
Name:

Password:
(Sponsors/Supporters only)

State:
Email Address (mandatory for non-subscribers and non-registered users!):

Subject:

Comments:

Advertising/Sponsor Information

Copyright © WMI, Inc. 1995-2014. All rights reserved.
This message board created and maintained by: WebMasters International, Inc. (WMI) address mail to wmi@wmi.org

WMI disclaimer
Privacy Statement
Google