|
|
|
|
|
|
|
|
SW Reports Surf Fishing SW Flyfishing Swap/Sell |
SW Fishing
SW Boats for Sale Striped Bass Shrimping |
Boating
Boat Ramp Electronics Trailers/Towing |
Texas SWF
Florida SWF NC SWF NJ SWF |
Fishing Cats |
SUBJECT: # 27866: Transducer Mounting
Submitted by west-end-willy (170.189.193.3) from TEXAS on 12/17/2007 11:42:00 AM
Hey guys. Does anybody have a way to mount the transducer cable on the transome without drilling holes in the transom? I was wondering if there is a glue or something. I have a new boat and I hate to drill holes in the transom.
- 12/17/2007 4:15:00 PM
Submitted by
Farallon (71.146.66.134) from CA says Transducer Mounting
I drilled my boat, but if I were to do it again, I would use a piece of starboard. Mount the transducer to the starboard and use a 3M 4200 Adhesive to glue the starboard to the transom.Starboard looks similar to a plastic cutting board, it is expensive.
- 12/18/2007 9:04:00 AM
Submitted by
Les (24.149.68.185) from VA says Hot Glue
I put mine on there with a few dabs of hot glue and it stayed on for over ten years.
