Saltwater Fishing Home PageTM     
Anglerworld.com


7-13-2013



Boating
Tackle Shops
Charters & Guides
SW Reports
Surf Fishing
SW Flyfishing
Swap/Sell
SW Fishing
SW Boats for Sale
Striped Bass
Shrimping
Boating
Boat Ramp
Electronics
Trailers/Towing
Texas SWF
Florida SWF
NC SWF
NJ SWF
Fishing Access
Fishing Cats

SUBJECT: # 27931: Merc 125 L4 - Questions about water pump replacement

Submitted by FreeOnBoard from TEXAS on 6/10/2009 1:57:00 PM

This belongs to a friend, he thinks it's a '96, and I told him it's probably a straightforward job if we can get the right information and supplies before we start. 1 - It appears from the pictures of the water pump kits that you normally replace the impeller, cup, and gaskets and reuse the housing; is this correct? 2 - Aside from the water pump kit, are there any special adhesives or greases required? Of course, we plan to coat all of the bolts with gasket sealer. 3 - What is the best manual for this motor? Haven't read anything good about Seloc, but the factory manual I got years ago for my Merc 400 wasn't very helpful, either. Thanks.


  1. 6/20/2009 8:48:00 AM Submitted by Les #11903 from VA says Manual
    What you've said is about right:

    See also:

    https://appcenter.mercurymarine.com/litreq/orderFormp?type=ob


  2. 6/20/2009 1:02:00 PM Submitted by Les #11903 from VA says correction
    Make that:

    https://appcenter.mercurymarine.com/litreq/

    then click on outboards


Go to next message

Category:


To post a followup to this subject use the following form:
Name:

Password:
(Sponsors/Supporters only)

State:
Email Address (mandatory for non-subscribers and non-registered users!):

Subject:

Comments:

Advertising/Sponsor Information

Copyright © WMI, Inc. 1995-2014. All rights reserved.
This message board created and maintained by: WebMasters International, Inc. (WMI) address mail to wmi@wmi.org

WMI disclaimer
Privacy Statement
Google