Saltwater Fishing Home PageTM     
Anglerworld.com





Boating
Tackle Shops
Charters & Guides
SW Reports
Surf Fishing
SW Flyfishing
Swap/Sell
SW Fishing
SW Boats for Sale
Striped Bass
Shrimping
Boating
Boat Ramp
Electronics
Trailers/Towing
Texas SWF
Florida SWF
NC SWF
NJ SWF
Fishing Access
Fishing Cats

SUBJECT: # 27865: Winshield

Submitted by DavidRPa. (71.161.255.195) from PENNSYLVANIA on 12/14/2007 5:41:00 PM

In the middle of refinish work on the center console for my 74 aquasport redo. Would like a line on replacement windshield suppliers. Any suggestions appreciated. thanks DR.


  1. 12/17/2007 7:58:00 AM Submitted by Dwight (216.164.129.149) from AL says Windshield.
    You can have a local plastics place cut and bend you a new windshield if you give them the dimensions. Use polycarbonate, it is tougher than plexiglass. Be carefull drilling the holes for the screws. Or try this site:http://dub_dub_dub.greatlakesskipper.com/index.cfm. Replace the dub with a "w". They have lots of interesting stuff there.


  2. 12/19/2007 10:20:00 AM Submitted by pt (192.172.8.11) from NJ says yup
    http://www.updplastics.com/windshields%20main.htm


Go to next message
Go to previous message

Category:


To post a followup to this subject use the following form:
Name:

Password:
(Sponsors/Supporters only)

State:
Email Address (mandatory for non-subscribers and non-registered users!):

Subject:

Comments:

Advertising/Sponsor Information BFHP/SFHP and Pop-Ads

Copyright © WMI, Inc. 1995-2008. All rights reserved.
This message board created and maintained by: WebMasters International, Inc. (WMI) address mail to wmi@wmi.org

WMI disclaimer
Privacy Statement
Google